New Publication in J. Mater. Chem. A! Congrats Trevor!
Bis(tri-n-alkylsilyl oxide) silicon phthalocyanines: A Start to Establishing a Structure Property Relationship as both Ternary Additives and Non-Fullerene Electron Acceptors in Bulk Heterojunction Organic Photovoltaic Devices
Previous studies have shown that the use of bis(tri-n-hexylsilyl oxide) silicon phthalocyanine ((3HS)2-SiPc) as a solid ternary electroactive additive in poly(3-hexylthiophene):phenyl-C61-butyric acid methyl ester P3HT:PC61BM bulk heterojunction organic photovoltaic (BHJ OPV) devices resulted in an increased performance. It has been hypothesized that the increase in efficiency is partially due to the unique and odd combination of high solubility and strong driving force of crystallize previously observed for (3HS)2-SiPc. In this follow up study, two chemical variants of (3HS)2-SiPc, bis(tri-n-butylsilyl oxide) ((3BS)2-SiPc) and bis(tri-n-isopropylsilyl oxide) ((3TS)2-SiPc) were synthesized to determine how small changes in chemical structure would affect the properties of the material and its performance within BHJ OPV devices. We observed that the use of either (3XS)2-SiPc compound results in a further ~10% increase in Jsc compared to the use of (3HS)2-SiPc. We also did a preliminary assessment of the use of the three (3XS)2-SiPcs as replacements for PC61BM in straight binary P3HT-based BHJ OPV devices. Despite achieving only ~1% PCE efficiencies, observations including a ≈ 50% increase in VOC over a P3HT:PC61BM baseline and a decent fill factor indicate to us that (3XS)2-SiPcs do have potential as non-fullerene acceptors and advantageous alternatives due to their low embedded energy and therefore their inherent sustainability. X-ray diffraction of ternary and binary BHJ devices demonstrate that both (3BS)2-SiPc and (3TS)2-SiPc experienced similar increase in crystallite density (d-spacing) relative to (3HS)2-SiPc which we surmise plays a role in the improved device efficiency. Like (3HS)2-SiPc, for these two new additives, we also observed a high tendency to crystallize. The results from this study suggest that solubility and driving force to crystalize are important factors in determining the extent to which an additive will migrate to the donor/acceptor interface and thus affect its performance as a ternary additive in BHJ OPV device. Based on the three (3XS)2-SiPcs used in this study, the smaller tri-n-alkylsilyl oxide molecular fragments seem to work better. Therefore, moving forward, we will continue to consider smaller molecular fragments that still enable solubility and processability of (3XS)2-SiPcs.
Find it in Publication section
To read the full article visit J. Mater. Chem A.